MY CONAIR HAIR TRIMMER #HC111RW WORKS WELL BUT I BELIEVE THE BLADES ARE DULL-WHERE CAN I FIND BLADES FOR IT?

Hello,
Here is the link to their online store where you can find parts and also new sets.
http://www.conair-store.com/category.asp?NAV=PERSGROOM&HDR=GROOMING&trk_src_ss=CONPAYPCWEBMACSS'PPC'ADW'conair%20hair%20trimmer
Thanks

Conair trimmers are only good for about a year and they are hard to put back once you have messed with them. does your blade pop off or does it have two phillips screws holding it in? If you take the blade off completely you should see two arms that are in there, you have to place the blades back on correctly and hold them together while putting the screws back in. be very careful not to tighten the screws too much. Oil your blades with 3-1 oil and then turn them on. adjust the trimmer and see if everything is level, if it is try cutting withem and see what happens. If the motor sounds good but the blades are pulling your hair rather then cutting it then you need to replace your trimmers because your blades are daul.

Call Customer Service at 1-800-326-6247

Sounds like you may need the blade sharpened, it may be dull, otherwise the motor may not be functioning properly. Does he have thick or coarse hair? If so, you may need to go through it lightly in sections otherwise it will for sure pull, I learned that way back in hair school long ago. :) Goodluck!

Hi. Order them from Conair: customer service representatives will be happy to help you. Please call 1-800-326-6247 for a Conair appliance.

Sure enough the blades have become dull. Change them

Take them off by unscrewing them and realign

digram on how to replace my blade in my hair trimmer conair hc3180v

Go to a Sally Beauty supply and purchase a can of the blade wash. It is relativly inexpensive. You dip your blades into ths special wash and it cleans the blades and keep them sharp and is safe. DO NOT take the heads apart, Let the pros do that but blade cleaner you immerse them in and trust me it is what we pros use.

There should be 2 phillips head screws on the underside of the cutting blades.loosen them enough to where the 2 cutting blades are able to move freely then take some 3-in-1 oil and apply some in between the blades and tighten the bladesback down.Turn the cutters on for about 30 seconds and they should be good to go.Rate me FIXYA! if this helps! GOOD LUCK.