When we turned it on there are two black blobs and abunch of lines on the screen

replace your display unite

The problem is the in the ccd circuitry in the camera lens, the aperture "shutter" is not opening which is motor driven, It will need a camera technician to look at it, but probably not cost effective to repair, cheaper to replace.

It sure sounds like you have cracked screen! post the pictures if you can or send them to me at [email protected]
Nobody hit the screen?

Normally a "blob" on an LCD is a delamination of one or more of the LCD panels. But, they are usually not black. You may have a poor ribbon cable connection from the main board to the LCD panels....there is a ribbon connection to each of the Red, Green and Blue panels. It's either that or a main board failure, but certainly soemthing you want the factory or other authorized service center to check out.

Good luck.

The blob is a phisically damaged part of the LCD screen. Unfixable, the screen must be replaced and it will be expensive.

try http://www.fixya.com/support/r3771170-phone_water_damage

best regards .

When you were done downloading, did you use the "safely remove hardware" action or did you just yank out the cord?

sounds like new touchsceen wanted.

hi there

you need to replace the screen because that means that you liquid matrix display ( LCD ) is already busted.

hope this helps.

My nokia N95 I just got from Tigerdirect.com few days ago, after I got home from work my phone was looking ok but the battery low, I charg the phone and I see little dot on the LCD I thaught some dirt inside the screen, two minutes later the black dot get bigger and bigger more and more line across the LCD display.

My wife watch it and she thaught I was joking, but I decided to call customer service then she believe it.