My GE dryer will not start on any setting. The

you need a new motor

Check the circuit breaker first in your panel by turning it off then on again.

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

I have a GE (Model #: DCL333EAOWW) Dryer that will not heat up properly and the timer does not work

check your breaker at the breaker box. or the thermal fuse has blown.

Use or borrow a volt ohm meter and check for a grounded hot wire. You may also be exceeding the start up load on the 20 amp breaker. Test this theory (after you make sure that there are no ground faults) by starting the dryer in a "air fluff" mode without heat. If the dryer starts in the "no heat mode", switch the heat on - if you blow the breaker you know that the 20 amp breaker cannot handle it. Before you do any of the above - check your dryer manual for the service requirments. If you don't have the manual go to the mfg. web site and download it.

This dude mounts on the heater housing, if it is open the dryer will NOT run. It blows when the vent is stopped up.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

also there is a main fuse under the top back,if it blows nothing works-mike

This may sound silly but did you check (or have the means to check) for voltage at the outlet? The absolute bottom line is that if there is no power.......you get the rest.

Possibly a door switch, or starting switch near timer assembly. it could also be a bad breaker, dryers have a double breaker, even if you are getting electricity to part of your dryer 1 bad breaker might not let the rest of the dryer work. With electrical experiance,and elect. tools, have some one test breakers and plug voltage.