My washing machine keeps stopping on the rinse cycle and then i have to skip the cycle for it to keep working.

i think the door has been banged
its not a tight fit bad seal etc..
so as to form an air lock

something like this i note from other forums

if it fails to stop running only at the rinse part of the cycle it is probably in the timer as the solenoid valve has to cut the water off when the washer fills for the wash cycle too. fills for wash cycle and cuts off water, washes and drains, refills for rinse cycle and water just keeps running? does this every time you run it? that's in the timer. bad solenoid (water inlet valve) would keep running even on wash fill up. hope this helps.

Check the washer drain hose for clogs.

I had the same problem before, but removing the kink in drain hose does the trick. Maybe yours is more complicated but try it.

It sounds like the cycle timer is faulty.

Make sure it is not on rinse hold or crease care, release if it is, make sure pump is working, and that the cold inlet valve is working., all of these things could prevent it from completing rinse cycle.
Plz rate this solution.
Thanks.

My Whirlpool washing machine is not stopping after completion of wash cycle instead it is repeating the cycle again. It is not consistent, but out of 3 washes 1 wash is happening that way...we are manually stopping machine by gaurding carefully when timer shows nearer to completion.

if if spins the belt is ok,may have timer fault or timer module ( next to timer) if fitted will be faulty

heater element may have gone, when you manually advance the settings you are skipping the heat cycle.