How do I change a Lanier LD335c heat roller - Lanier Office Equipment & Supplies

Heat roller error

If the toner hopper assembly is not broken the mylars inside of it have fallen off over time. The toner supply unit needs to be replaced.

Very, very common issue on these normally related to a problem in the toner hopper assembly itself.

Check IP address sub net, ect?

You need to check the network address of the newly connected network. you said it was connected to a network A (e.g. 192.168.1.0 subnet mask 255.255.255.0 or /24) and now you are connected to network B (e.g. 192.168.2.0 subnet mask 255.255.255.0 or /24). Your device had an ip address assigned in the old network, could be 192.168.1.99 this ip can not communicate with the new network 192.168.2.0, you need fir to find out what is the new network address and subnet you need to ask your network admin. and then modify the setting of your router to be part of the new network.

This SC-320 code error occurs when polygon mirror motor fails or poor connection between BICU & polygon mirror motor please check first the connector of motor if you feel that the connector is good change the polygon mirroe motor it sits inside the LD unit please call the expert to change the part
thanks

Make all your settings on the copier side as if you were going to copy it. Set the duplex for 2 to 2 as I am assuming your original is 2 sided and any other settings you need. Then select the document server button, set your document name (if you want to change it from the copier default) then press the print button to scan it in. Pretty simple but if I understand your question correctly this should do it. The trick is you need to select the duplex/color/ etc settings before you go to the document server screen.
Good Luck

Hello the Display work like this insert the tape on the Lanier VW260 with the unit on rewind the tape to the end when you press play the Display start to count

You can change the time setting by pressing "UserTools" the selecting "System Settings" and then selecting "Timer" settings. There you will find the time setting.
If you do not have a manual for your copier you can download it here:
http://www.lanier.com/downloads/Default.aspx?hbn=manuals

From the Ricoh-Lanier Error Code Sheet:
SC302: Charge Corona Output Error 3 - Grid Voltage error - Charger Roller Current Leak.

I would suggest replacing first the charge roller and if that doesnt fix it, the HIgh Voltage Supply Board.