How do I know if my msi ft200 is charging. No light is coming up when I plug it in. Then when I unplug it, it doesn't do anything. Please help

I can't see that anyone has commented so far :-(
Sounds like a dud battery, and if new should be returned. It would help if you can borrow a voltmeter and test that both the charger and the battery show a voltage. [a local electrics shop may help there]

Sounds like a Power Supply problem. This problem will probably require a live, in-person tech, especially if you have no hands-on experience. Do you know anyone with soldering experience or other electronics hands-on experience? If so, I could communicate a process to them. Tx, Petra

Hello! It seems that you have a problem with the laptop charger connector. It maybe in short circuit. You can try to look for some electronic workshop that works with reballing, BGA solder, etc., that might change it. In Portugal we have some, so I think in other countries you can find them to.

With most bluetooth devices on the market today, the default pass key code that comes programmed with the device is "0000" (four zeros).

HI Cws666, try to charge your computer for a full 3 - 5 hours without interruptingit, than try again.
If that doesn't work, try buying a new battery.
If that doesn't work send it to computer's brand labs.

No JJR all the plugs need to remain plugged in. On the Pride chairs the light on the charger will only come on green when the batteries are fully charged. When you unplug the controller the charger thinks the batteries are fully charged and the light comes on. Now the problem is the batteries. If they are old or you have a bad battery then the charger never senses a full charge so no green light. Hope this helps

Try unplugging it and removing the battery. Wait a few minutes. Yes actual minutes. Then put the battery back in and try again.

When you get back in try rolling back to a restore point when you know things were working well.

Could be a software update of some kind threw things out of whack.

dear sir.

yes u have to do one thing first you can do yr laptop need to setup some physical settings if you know bout hardisk located then plug out and then on your laptop if laptop is working then turn off it and take battry of then plug harddisk in then re start yr laptop do same as RAM if u know how u unplug both device and be carefull... it's help u..:)

Thanks
please vote
jo_chinmay

Charge the Battery fully before first use . The red flashing indicator shows that the battery has been deeply or fully discharged . Please Connect your laptop to AC power source and let it remain for well over 10 hours atleast.If the battery pack is alive it might recover and start working normally.

On my Colby player there is a small reset hole in the back. Mine has sometimes just stopped playing and shuts off. If you use a small wire (paperclip works well) push it in and reset it.