How to remove winder on ap13ak thicknesser

Have you sharpened the blades? Some use spiral blade that need touching up ever so often.

Remove screws from arm rest,check under door edge for screws remove door handle and window winder if it's not electric now unclip the cover using a flat blade tool like a paint scraper and prise the cover clips off.

Remove handle ,window winder if not electric,remove arm rest screws prize door trim off carefully using a flat blade or screw driver.window winder is held on with a horse shoe clip which can be removed with a piece of wire with a hook in the end.

Refer to your manual.

Hello proh.... here is a link that may solve your problem http://www.ehow.com/how_5598130_change-ryobi-planer-blades.html



and here is a set of short videos that show step by step how to do this.
http://www.ehow.com/video_4420138_change-worn-blades-portable-thickness.html

you do need to remove the door handles to remove the door trim panel, if it has arm rests on the panel look for 2 or 3 plastic plugs which only press in and are easy to remove with a blade, if they are not present the arm rest may be part of the trim as one unit.
the winder handle may have a spring clip behind the handle and the trim, if that is the case you will need a special tool to remove the clip. also check for any screws that may be holding the panel to the door, when all screws etc are removed just lever the panel away from the door with a flat blade or screwdriver. hope this info helps

Press the R1 and R2 release buttons. Pull up on winder handle until the back of the camera opens. Continue the pressure on winder handle until you have removed the film canister. Insert new film canister. Pull leader across winder assembly. Close camera back. Press exposure button. Press winder handle in towards camera b

mmmm from what i can recall 2 screws in arm rest (two small holes underneath arm rest hides the screws)take these out also one in door handle trim behind handle, And the window winder if you look close in the gap between window winder and door trim you should be able to see a curbed metal pin this holds winder in place so to remove it get a knife ( thin blade will fit in between winder and trim) and push on the end bit of the metal pin and it should spring off and then door handle can be removed. After this run your hands around door trim gently pulling around all edges ect this will pull door trim away from supports

Remove plastic studs from door closer. Unscrew three retaining screws. remove grab.
Unhook window winder retaining clip. Best done with small long-nose pliers. window winder retaining clip located inside plastic winder handle section. Will need to prise away winder handle from door slightly to expose clip. locate and gently pull clip from winder shaft.
unscrew door opener / lock assembly retaining screw.
gently prise lower trim retaining press studs from door. remove lower trim.
gently , from rear of door, pull upper trim from door and similtaniously prise upper trim press studs from door.
gently giggle door opener / lock assembly through upper trim . remove trim
gently with flat blade, peel off plastic dust sheeting.
access to inside off door is now possible.
Reassembly reverse of above

Cheers !

ozzy11