<!-- from fixya rte -->E0 flashing on hoover hnc 6200 wne - Computers & Internet

https://service.hoover.co.uk/advice-centre/washing-machines/dynamic-next/

Flip them upside down and mount in other side.

no. dust will get into motor and burn it

it could be that you need a new drive belt or it's the idler wheel that is under the drum.just put some wd40 on it

the filter care light comes on when the machine is over heating so the "brain" thinks the lint trap is full , clean the entire venting system, including the outside vent cover and remove any debris , then unplug the machine for a few minutes and see if it resets

My turbopower 6200 does not seem to be picking up. The beater bar I don't think is working?

i need the serial # to assist you better 
thank you

Most Hoovers if you turn the vac over, remove the plate covering the brush roll, then you can get to the belt and brushroll.

Since no help was available without premium assistance, I actually contacted a repairman. He performed all the tests again and told me the problem was the control board. Then wanted $600 to fix. I found the part online for $150 and fixed it myself in about an hour. Instructions were easy.