Functional problem within the copier. sc1-195

Try -
http://www.youtube.com/watch?v=3kJ1bc8KD48
except I think you need 7 data log to reset scr

Black TD sensor problem, check development unit connections

change the td sensor below the developer unit or if possibly change the complete developer unit

LD unit beam pitch adjustment incorrectly.

hi
How do you treat this problem Please circulate the solution Video

look my friend 101 means that check that scanlamp light in main scan and check mirrors and lamp staplizer is worked

this error belong to softwer yo must install via ac cards

try plugging it in or using carbon paper

The applied power supply ac frequency
was detected at over 66Hz or below
45Hz, and the zero cross signals are
not detected within a certain period
within 500 ms after the main power
switch has been turned on. Pls check power supply board or try to use an AVR (autonatic voltage regulator)

This is a fuser temperature heating error.
the fuser has not heated up within 5 minutes after switching the copier on.
Most likely cause:

Heater lamp blown
Thermal fuse blown
Faulty power supply
Bad connection to fuser unit

You will need a service technician to fix this.