At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Caterpillar troubleshooting im working on a 268b cat skid steer i replaced the drive motor right side the one i remove had destroyed the brake discs after trouble shooting for a mettalic noise when i put the right side into drive the new drive made a noise bottom line i got to thinking maybe the brake is hanging on so i put a t in the line to the brake i have a preasure of 200 psi i think i need say 600 psi can i adjust this or do you have another idea
This question got put under shoes. If the manual says the pressure should be 800 psi, then run with that. This sounds like a challenge and the manual is more of a friend than me!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Jul 24, 2012 - The water pump,thermostat,engine oil cooler have been replaced and ... Ask an Expert .... We have a 2005 JD 240 skid steer and it has been slowly overheating and getting ... the radiator and replaced the thermostat but problem continues. ... But after I ran the machine it now has very limited brakes and the ...
start with battery ,got juice go to starter ,if cranks,. go to fuel filter, pull drain plug drain some fuel to make sure theres no water. if no crank inspect wire to starter and ingination. cold weather can cause problems with start
check with the service dealer
most skid steer loaders do not have brakes in the normal sense but have valves that lock the hydraulic fluid in the drive motors and so prevent them from turning making them brakes
? 2:27
https://www.youtube.com/watch?v=WBWVSpgZkKQ
Dec 27, 2014 - Uploaded by rayray haque
I made this video because I recently had to fix the drive chain on my skid steer. But there were no easily ...
Remove the hydraulic motor on that side and have the motor shaft seals replaced . If there is a seal on the shaft in the housing as well check it out as there is a chance that dirt and mud is what caused the seal to fail
After looking and looking, opening every bolt on the floor of our Bobcat 773F skid steer......it absolutely wasn't there. Finally found it, opened the engine compartment door in back. There it was on the lower right side. The fuse chart is posted on the lower part of the door. Don't know if because this is a 773F model that the fuse box location is different from a 773.
for remove the bobcat fuel tank you need remove first the motor or if do you want to clean the fuel tank you only need remove in the botton side the steel bar with 3 screws and remove the fluel tank plug.
With all the hyd pressure released, need to unhook the 2 big hoses going to the hyd motor on the chain case on the left side and CAP OFF with fittings. Next start the machine and SLOWLEY move the travel control for the left side a little front and back, you should hear a loud growl from the hydrostat, showing that it is pumping under load. Dont do this long, but enough to test. No noise means the problem is in the hydrostat, possiably bad slipper plate, rotating group or both high pressure relief valves.If you have noise the problem is in the hyd motor. Good luck and be carefull!!!
×