No subwoofer with Ipod or CD but works with Radio - CDA-9885

The ipod cable plugs into the rear of the stereo. Here is a link to the installation manual:
http://vault.alpine-usa.com/products/documents/CDA-9885%20OM.PDF

there is no code for an alpine cda 9885. what seems to be the problem with the radio?

you can try removing the faceplate and cleaning the copper contacts with a pencil eraser. This might help

Hello billybob3491,

The best way would be to add the Alpine optional proprietary iPod connection cable. This will give you full control of the iPod from the radio. Your CDA-9885 uses the KCE-422i optional cable.

The cheapest way (with lower quality audio) would be to use a generic FM modulator with a mini-jack input. The Scosche FMMOD01 shown here is sold in numerous stores from $17 - $50. Another downside with this method is that you have no control of the iPod from your head unit. But, hey! It works.

Hope this helps.

I had the same problem. I got it resolved by making the MIX OFF. Just press the button number 5 to make the MIX (Random Play)ON/OFF. After the search you can set the MIX to ON. However set the MIX to off before you start any search every time.

The Alpine has two tigger wires when it turns on. One is an AMP TURN ON wire (blue/white) and a PWR ANT wire (blue) and that wire only comes on when using the radio or an optional HD radio unit ... When it was installed/connected . someone hooked your amp turn on wires for your "full range amps" to the PWR ANT wire. And the sub amp trigger is either hooked correctly to the AMP TURN ON WIRE or somewhere else, it probably shouldn't be... Check it. Amp triggers should all be to the blue/white wire from your alpine. Warning: Alpine trigger wires, are very easy to mess up they supply a very limited amount of power.

have you fixed it yet? if not try this. your car probably has factory amplified speakers. hook up the remote wire AND the power antenna wire to the blue factory amp wire and it should work just fine

My ipods fuction fine with my Alpine CDA-9885 ... have you tried pressing the display button on the Alpine? The KCE-422i cable takes quite a beating ... You might check the cables.

Disconnect whatever is attached to the BLUE wire at the back of the Alpine deck. Re-connect it to the BLUE/WHITE wire instead. This should solve your problem.

did u remove the transport screw?