Green blue button - Jabra EasyGo Bluetooth Headset

Red = Audio
Green = Zoom
Yellow = Recall
Blue = PVR List

Check coil connection to harness is solid. But, I suspect your start button wiring is bad -- should be replaced (yes, the whole switch assembly).

1. If the Supertooth 3 is on, turn it off by holding down the green Multi-Function button for about 5 seconds (until you hear a voice announce "BlueAnt ST3 powering down").
2. Hold down "Vol +" and the green Multi-Function button until you hear a loud siren/distinctive tone.
3. The Supertooth 3 will turn on. Hold down the green Multi-Function button for about 5 seconds to turn it off again.
4. The Supertooth 3 has now been reset: all pairing and other information has been deleted. When you turn the Supertooth 3 back on again it will prompt you to select a language and then go into pairing mode.

You will now need to re-pair your phone with your Supertooth 3.

Hi - I had the same problem setting up my 3G S. Here's the solution. In "Settings/General" set the Bluetooth to "ON". Turn your ST3 OFF by holding the green button until she says it's Powering Down. Now press and hold the green button ON until Language Selection (British English) option. Select language by pressing green button again. Next she will say "Device Found-Paring Successful-Enter password 0000". Enter 0000 and your phonebook will start downloading. There ya go!

Hold both the blue Fn and the green Call buttons for a couple of seconds, and, then, press the reset pin with the stylus pen. When you release the buttons, a screen will come up asking for confirmation. The hard reset will start only after you confirm the procedure, by tapping on hte left softkey.
Hope you are able to sort your problems out soon.
Cheers! Carlos

CLICK HERE for a PDF copy of your owner's manual.

Page 17 States to change the display color -

Setting the Multicolor Illumination

ILLUMI BLUE (Initial setting) / ILLUMI GREEN/ILLUMI AMBER /
ILLUMI RED

You can change the lighting color of the following four buttons:
SOURCE/POWER, BAND, (left << arrows) and (right >> arrows).

BLUE > GREEN > AMBER > RED > BLUE

• According to the lighting color of the above four buttons, the color
of the other buttons also changes. When the color of the four
buttons is AMBER/RED, the color of the others is AMBER. When
the color of the four buttons is BLUE/GREEN, the others are also
GREEN.

Thanks for using FixYa - a FixYa rating is appreciated!!

its on the side of tv! but 1st take on the black lable on the back than push that button in than the red green and blue will can on ones done put black lable back on and thats than good luck

The blue means the germicidal lamp is operating. Re: green light - Normal operation at all power levels involves a pre-programmed cycle of altering high and low air movement. Press the the green to override the regular power control setting and run the unit at maximum power for five minutes. Your previously selected power level will resume after the five minutes has elapsed.

Charge your Supertooth one via the car charger or by attaching a usb/mini usb cable to your computer usb port. Need to charge for 4-10 hrs. Indicator light glows red (needs charging), orange (charging) or green (charged)
Power on: Press green button for 1 second. Indicator light blinks blue. A beep will be heard
Power off: Press green button for 1 second. Indicator light turns red. A beep will be heard

To pair with your mobile phone:
1. Press green button on Supertooth for 5 secs until indicator light blinks red/blue 2. Access bluetooth menu on your phone. Turn bluetooth on. Execute a bluetooth search. 3. Select ST ONE from list 4. When phone requests password enter 0000 and press OK 5. The handsfree kit is now ready for use 6. Clip Supertooth on sun visor of your car so that the microphone and control buttons are directed towards you. 
To make a call: Dial number on phone. Supertooth will automatically connect. Indicator light is steady blue during call
To end a call: Press red button for 1 second
To answer a call: Press green button for 1 second. The bluetooth indicator will turn a steady blue.
To increase/decrease volume. Press volume buttons repeatedly up or down. They are situated between red and green buttons.
Hope this helps.

need make and model