Idect Q1i key pad locked no buttons work, padlock symble on screen between menu and pb

Reset Your Phone

1. Press <MENU/OK> and <UP/DOWN> to select DEFAULT.
2. Press <MENU/OK>
3. Enter the 4-digit system PIN(default 0000).
4. Press <MENU/OK> to display CONFIRM?
5. Press <MENU/OK> to confirm, and the phone will be reset to its default.

Registration; Reset Your Phone - iDect Link Plus Single User ...

Try pressing and holding the Clear/Off button for 3+ seconds. The LOC indicates the control panel lock is enabled. The LOC should clear from the display. Note: if you hold the key pad for too long, the lock will reengage. From the picture of your range that you included, I believe this is the key pad button just below 7 to the right of the LCD display. There is a label in a small font just below the key pad. (The label probably is a padlock symbol and the word Controls but I can't resolve it from your picture.) Some newer Frigidaire Gallery ranges have a key pad button with a padlock symbol; this would be the correct button to press and hold on those models.

Warning: on some models, the door lock will also engage. Do not try to force the door open. Wait for 15+ seconds for the door lock mechanism to fully disengage before attempting to open the door.

I hope this helps.

Cindy Wells

When registering dont forget to press and hold the paging button on the base station for around 10 seconds to put the base into registration mode. The PIN will be 0000 unless it has been changed, to reset without PIN: Hold Paging button, disconnect power (whilst holding Paging), reconnect power still holding paging button. Any further queries call the Helpline on 0845 345 9677.

Try the following: press and hold the * button on the keypad to toggle the keypad lock. (There is a small icon that looks like a padlock on the key.) This works on the later X2i model.

For the user's guide, try: http://www.binatonetelecom.com/support/user-guides . Unfortunately, my browsers aren't working through the site properly. I see the X1i on Amazon but not on the Binatone site.

I hope this helps.

Cindy Wells

Do you mean Key Pad Lock? if it is so then follow .... Return to the Screen mode by pressing the RED button on the Right Side - Press the Green button on the Left side just above 1 and again press star * but you should do it within 5-10 seconds .. Good Luck

There is a scan of the idect q1i manual here.

That is the OSD (On Screen Display) system built-in to your computer monitor. Check that when you hit the ON/OFF button on your monitor, that you do *NOT* hit the 'OSD ON/OFF' button.

Most of the time, the OSD will disappear after 10 seconds of "non-use".

You need to press the Function button, then the num lock button. The function button may be labeled FN or F in a different color, the same color as the num lock button.

If that doesn't work, go to start, all programs, accessories, accesibility, on screen keyboard....it will display a regular keyboard on your screen, then click on the num lock key on that keyboard.

go to menu registration
select base
enter pin 0000
press ok

Hold the menu button until the padlock unlocks, it takes anywhere from 30 seconds or even a minute or so