Audio Players & Recorders Logo

Related Topics:

Anonymous Posted on Mar 28, 2013

I need to figure out how to install my alpine amp for my JL Audio SubWoofer . The problem is i am unable to determine which cables and wires go where on my BMW 540 i . Year model 1999. I have been s

I need to figure out how to install my alpine amp for my JL Audio SubWoofer . The problem is i am unable to determine which cables and wires go where on my BMW 540 i . Year model 1999. I have been searching for a way and i am still so confused after hours of searching the web. Can u help me please?

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 4 Answers
  • Posted on Mar 29, 2013
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Problem Solver:

An expert who has answered 5 questions.

Joined: May 05, 2009
Answers
4
Questions
1
Helped
646
Points
8

This should help you out dude. Please Rate or let me know if this didnt help. Switched 12V+ Purple Ground Brown Illumination n/a Dimmer n/a Front Speakers 5 1/4" Doors Left Front (+) Yellow/Red Left Front (-) Yellow/Brown Right Front (+) Blue/Red Right Front (-) Blue/Brown Rear Speakers 5 1/4" Rear Deck Left Rear (+) Yellow/Blue Left Rear (-) Yellow/Gray Right Rear (+) Blue/Purple Right Rear (-) Blue/Gray

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have an Alpine PDX-5 amplifier powering my door speakers and my JL 10 w3v3-2 ohm subwoofer. The door speakers are still working, but the subwoofer has stopped working. Every once in a while it will...

check the power and ground and also the turn on lead that goes to your radio for a loose connection if thats not it then your amp may not be working or the subs
0helpful
1answer

Amplifier causes subwoofer to emit super high pitched sound

YOU NEED NO CHACK THE GROUND CABLE SOMETIMES WITH THE SAME POWER THAT THE AMP NEED START TO BURN THE CABLES AND IF THE GAUGE OF THE CABLE IS NOT THE CORRECT CAUSES THAT PROBLEM TRY TO PUT 2 GROUND CABLES (GREY) IN DIFERENT PLACES AND IT MUST WORK!
1helpful
1answer

Alpine in dash tv issue

this is the problem with the additional battery wiring. use appropriate cutout and do rewiring. make sure the Dynamo has the enough capacity to charge both the batteries. better avoid using your music system till the problem is rectified.
0helpful
1answer

Got jl300/2 amp confused which subwoofer sounds good

Hello drsubhakar26,

JL W6's will perform well with from 150-600 watts RMS. W7's with from 150-500 watts. Less expensive Alpine Type R's work OK with from 200-500 watts RMS. Either of the brands will sound good. None of them will perform to their full potential with 300 watts RMS. Powering any sub with a 2-channel amp is a compromise. A monoblock is more efficient.

Hope this helps.
2helpful
1answer

What would be a better amp for my jl audio 12in w6v2

its not the amps my dude ur ohm loading is wrong if u have a 4 ohm stabled amp n ur speakers r 2 ohms naw thats not gonna fly caus it cant put out what ur asking 4 so u need 2 reload ur subs try this link http://www.bcae1.com/spkrmlti.htm this should help u out n save u money
0helpful
1answer

1 10 jl jl 250/1 mono block amp cuts off an on help

your subwoofer is wired incorrectly to your amplifier. Figure out which ohm load of subs you have and then what ohm load options your amp is stable at. Next go to either the Crutchfield website. find their learning center. go to subwoofer wiring diagrams. or go to www.the12volt.com and find their section on it
0helpful
1answer

Equipment not turning on!???

Have you tried checking the remote wire yet? Because it could very possibly be that. Without a remote wire hooked up, you cannot get any power. Try that and see if it works.
2helpful
2answers

My amp shuts off with my 12in w6's when i turn up the volume

oh no you need a more powerfull amp i recommend selling the one you have and upgrade to a bigger amp ive had the same problem or if not unbridge your amp so it dosent work the amp to much
0helpful
1answer

Hi, I've just install an alpine power amp with JL 10inch subwoofer, everything seems to be working properly except for the subwoofer

If you have the RCA's running from the head unit to the amp, and the speaker wires running to the speakers then you have it hooked up right. Now If you still don't have any sound then you need to look at the amp to make sure that you have a green light. Still I would use 8 or 10 gauge power wire and then the same for the ground wire, make sure that you have a good ground.

Freakville03
0helpful
1answer

Ohm load???

You can't wire a pair of single voice coil 2ohm subs to achieve a 2 ohm mono load. Too bad you don't have 2 four ohm SVC's. Sorry
Not finding what you are looking for?

71 views

Ask a Question

Usually answered in minutes!

Top Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

SmartAviator
SmartAviator

Level 3 Expert

1124 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you an Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...