How to take apart 3m ls1000 laminator - 3M Heat-Free 12 Laminating Machine LS1000

Not much on it apart from a few short videos

https://www.google.com/search?q=ultima+65+laminator+disassembly

..

You would need to contact 3M on this.

If the laminate is just a "protective shipping" laminate, you should be able to peel it of.. if its not that.. I would not try to remove it... it may cause the blades to de-laminate ..or other wise start to "fall apart".. and thats NOT something you want to happen in ceiling fan blades..at high RPM..

Are you letting the laminator reach operating temperature? If the ready light is on and it is not getting hot then you may have a problem with the temp. sensor. Put your hand near, but not on, the top roller to feel if it is getting hot. Don't touch the roller in case it is hot. If it is getting hot then wait for the ready light to illuminate(about 10 minutes).

3M Scotch TL901 User Manual

did you get it fixed, I had the same problem but with a different part , I know where your part go's

1st without screw holes go's in the Rear where the laminate comes out and the next one goes on top email me if you didnt fix it yet , I can open mine and get pictures Email me here
[email protected] Subject Laminator APL-330U

well it sounds like you may have cut a wire or pull one somewhere. i would go ahead and take it apart carefully and check everything. may have unplugged something hopfully! let me know whwat happens!

Can you please provide a model and brand for the device in question?

This is a fault in the LCD itself, and is caused by a problem in the LCD itself or the ribbon attatched to it. Try taking the camera apart and reattatching the ribbon, if this doesn't help, a new lcd is order, which can be purchased from amazon for usually around $20.

my laminator ate the paper inside the laminator jacket; how can I get it out?