Whirlpool Gold Resource Saver GI6FDRXX- do you really have to manually reset if you lose power?

http://www.kolpak.com/search.aspx?searchmode=anyword&searchtext=38823S

Try the resource center. I found a few manuals but this site is not very user friendly. Have to kinda surf around.

Try holding down the energy saver and alarm buttons at the same time. Hold them down for 30 seconds. You might have to try a few times.

33 E code, hold energy saver button and the lighting button at the same time for 6 to 10 seconds

I am not a mechanic, but I do like to fiddle around with problems, to sort of i give my hand a 'try' at it. My next venture is to unplug the freezer, let it stand for a few hours, and re-plug it back on and see what happens. You never know. So, let's give it a go. That's it for now for me.

https://feg.hobartcorp.com/resourcecenter/ProductDocumentation/TR35748%20G-Manual%20(3-09).pdf
Try this site.If you can not access this, let me know and I will try to email to you this manual. It has info on your controller and programming.

Good day,
When the thermostat is turned on, the fan and compressor should come on and start at the same time. If the compressor continues to run and the fan doesn't, then the fan motor or the wiring to it are suspect.

Quote (The fan motor is o.k ). I doen't know how you tested it, but it still remains suspect, since the thermostat sends power to both of them at the same time.

Brand and model number necessary to diagnose your problem .

Just had the same problem on my Freezerator, the compressor would cycle on for a few seconds and then off for about 5-10 minutes. No cooling. Replaced the overload sw and the start capacitor and system running cold and tru. Beer cold again, 0deg in freezer. Parts are available on the web, P/n 2169373 for the capacitor and 213615000 for the switch and housing...may be different # for the sw....PTM

Yes, it does have a control board. It is located under the rear of the freezer near the compressor. There was a service bulletin out a few years ago about the exact problem you are having. I will not be able to find out if your freezer falls under this design change until tomorrow when I get on my computer at the shop.
What is happening is the board has a fault in it that won't allow it to come back on sometimes if the power blinks off and back on. I am not sure if the repair credit is still active but we have changed the control boards on many of these units free of charge as recently as a year ago.
I will reply back when I find out for sure.

sounds like you may have a refridgerant blockage in the system. it may need a regas to see if it can be unblocked, as this is not a quick job it may cost you but phone around on the cost/feasibility of it. it may be just as well to get a new or second hand freezer.