How do i change pickup teeth on john deere 500 baler ?

Question edited for a lot more clarity.
Question mover from Boating to a John Deere category.
http://salesmanual.deere.com/sales/salesmanual/en_NA/tractors/2014/feature/serviceability_and_support/serial_numbers.html

more here, but it seems to be coded

https://www.google.com/search?q=john+deere+466+hay+baler+serial+number+decoder

..

Question edited for full maker name.

Belt supplies in the link

https://www.google.com/search?q=john+deere+335+baler+replacement+v+belts

..

Found several John Deere 567 bailers with serial numbers close to that.
E00567X316985 2005
E00567X315479 2005
E00567X326503 2006

ask here http://www.mytractorforum.com/12-john-deere-forum or here http://www.tractorbynet.com/forums/john-deere

I wish I could have found a free copy.
$50 on ebay with free shipping.

John Deere 435 535 Round Balers Technical Service Manual CD TM1472 TM1472CD

Been long time. I think its a shear bolt. Should drive straght out. Put same grade bolt or shear bolt back in.

Depending on model of baler/belts you would shave of enough rubber to get a smooth surface.then put tool in vise with fastener in it,be sure pin is in slot when crimping or fastener teeth will not be squared up in belt and make it hard to get belt pin lined up when putting back together.Is there paper along each side of fastener?If so leave it there until done crimping.

You can follow this link to the JD parts catalog for your 435 baler. It has pictorials for each section of your baler. http://jdpc.deere.com/jdpc/servlet/com.deere.u90490.partscatalog.view.servlets.HomePageServlet