20 Most Recent
Hotpoint RGB745 Gas Kitchen Range - Page 7 Questions & Answers
Gas stove, oven has black soot all through it
There is a lever on the gas valve at the back. Flip it from what ever position it is in to the other positin and see if this helps. Valve is where the gas line connects. Small lever.
Oven says F2
F2 code means.
Oven too hot
Replace relay board (if present) or oven temperature sensor
Good Luck
When I turn the oven on the igniter glows but he
When the igniter glows but the gas does not come on it is usually the igniter not reaching the correct amp draw.
When the igniter does not reach the correct amp draw it may allow the gas valve to partially open or not open at all. The igniters are inexpensive and easy to replace. This video will walk you thru the correct procedure for testing an oven igniter. It may be a different model but the testing will be the same.You can also enter your model # for diagrams and illustrations of your specific model. Not all models are available. All parts come with installation instructions.
Now if the oven is staying on all the time, this usually indicates the relay on the main control is stuck/melted in a closed position. This will mean you will need to replace the control again.
Oven will not light, initiation
looked up your model this is a 2 burner oven top one for broil and bottom for bake . try using the broil and see if it gets hot you can see the igniter in the top of oven and in the bottom of the oven under the plate is the bake ignitor .. i belive that the bake ignitor is not working and will require a replace pt # wb13k0004 .. you have to lift out the bottom plate to get to in find two screws in the back on each side.. , hope this helped mm get back with me for more help if needed . mm feed back pls ..
The spark on the right front burner is not
It is possible either the electrode or the ignition cable from the spark module might be faulty.
Refer the
attached diagram. The electrode is part 154 at each burner should have one. The spark module is item 110. You could trace the cable from the right front burner electrode to the spark module to check if the connectors are not loose or coroded.
RGB745wea7ww gas oven comes up to temp but wil not
The problem is usually the igniter not reaching the correct amp draw .When the igniter does not reach the correct amp draw it may allow the gas valve to partially open or not open at all. The igniters are inexpensive and easy to replace. This video will walk you thru the correct procedure for testing an oven igniter. It may be a different model but the testing will be the same.You can also enter your model # for diagrams and illustrations of your specific model. Not all models are available. All parts come with installation instructions.
I set my oven to automatic cleaning, then
Hello- You may have already tried this but first I would try unplugging the range for a minute or so (you could also switch it off at the breaker) and see if the door lock will reset once you plug it back in. There are a couple of other methods I have used as well. Hold the door shut tightly and then set it to clean, sometimes the door lock will disengage and unlock before it attempts to lock again; you may be able to see the latch moving and can open the door when it unlocks. Try also to set the oven to clean and then cancel it again, it may reset. If these methods fail you may have to call a Tech to come out and see if the oven control is communicating with the door lock correctly. Good luck, best regards.
Not finding what you are looking for?