Question about Yamaha V Star 1100 Classic Motorcycles
...It is unlikely the clutch plates are sticking. Recheck the side stand switch. More than likely if it has oil and the stand switch is good , your problem is the clutch safety switch on the handle
Question about Yamaha V Star 1100 Classic Motorcycles
...Do not use any oil that says anything like "Energy Conserving II" or higher. Bikes use a wet clutch and those automotive oils have friction modifiers that will make your clutch slip. Stick to ...
... Do not use any oil that says Energy Conserving on the label . It will shorten the life of your wet clutch and transmission gears. Synthetic oils will help your bike run cooler and shift easier. I ...
Question about Yamaha V Star 1100 Classic Motorcycles
...the engine block ,but there is no fill stick or mark how do you know when it is full,and does the clutch use the same oil or have its own fill hole,gary Your best bet to address these questions and ...
Question about Yamaha V Star 1100 Classic Motorcycles
...clutch in. Is the bike fuel injected or carbs, if its the former than you will need a fuel injection specialist to reset it. if its carbs then it sounds like the idler jet is blocked or the needle ...
...which is the volumne. the window is often near the gear shaft, on some bikes its on the rhs on the clutch casing,its always low down , hands and knees job. old oil can blacken the glass on the
Question about Yamaha V Star 1100 Classic Motorcycles
...a nudge then it gose back into place. i have checked the springs on the shaft and all seem ok. the clutch works fine and can select gears ok. coud this be a slight bend in the shaft or is there ...
Question about Daytona Motorcycles
...clutch is sticking and not completely disengaging. Clutches get gummed up and that is why they stick, causing the bike to walk when put in gear, also cause the gears to grind because the clutch is ...
sticking clutch plates I am having problems with sticking plates of my motorcycle. Apparently every item of the sistem is runnin ok , but when the bike is stoped for 3 or 4 days the clutch does not ...
...clutch plates could be sticking: here you'd have to take the clutch cover off and get to the clutch. Remove the clutch (usually an impact is ideal for removing the clutch holding nut. Take the clutch ...
197 questions posted
Usually answered in minutes!
469 Questions
188 Questions
110 Questions
106 Questions
77 Questions