...oil. The engine oil is the gearbox oil. It's dry sump so you fill at the dipstick on the frame backbone. Milleraba is in the ballpark on the oil volume. Unfortunately you need to start the engine and ...
engine oil to spec Slightly warm the engine remove oil filler cap remove sump drain bolt and allow to drain remove oil filter cover and remove oil filter wipe out excess oil with clean rag install new
...oil seal is the engine breathing hard??? if it is then all this air thats forsing oil out is from the cylinders its getting past the pistons and blowing into the sump,,,in two words,,,your engine is ...
...need a small funnel. Use four stroke motorcycle engine oil 20/40( not car oils which can cause clutch slip) about 1.1 litres. and you need to run the engine a few minutes before checking the
Question about Yamaha YZ 426 F Motorcycles
...condensation may occur in the engine & forks & the resulting water can affect the oils If there is water in oil it will get churned into a white froth or the oil will go opaqueRide ...
...engine oil will i use as . As i have just bought a yzf426 2002 with no manual In the UK climate, I would use a 5W 40W semi synthetic. That will cover you if there was synthetic oil or Rock oil in the ...
...oil change Yes if you have the dip stick in the frame up by the petrol tank then you need at least 2-3 minutes of engine idle time to get an accurate reading - you basically need engine at full ...
Question about Yamaha YZ 426 F Motorcycles
...oil is coming from the engine lubrication system and it sounds as if you have not renewed the rocker cover gasket when the engine was rebuilt. Check the torque settings on the head bolts and that no ...
does a yz 426 tae tranny fluid? No. The engine oil and transmission are the same. Use recommended engine oil. (5w-30, Yamaha sells good semi-synthetic and synthetic)
204 questions posted
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
316 Questions
292 Questions