...power straight to coil...... any ideas Test the coil. Using a DVOM (Digital Volt Ohm Meter) , check the resistance of the primary winding of your coil. Disconnect the wires from the small wire ...
power to coil?Do voltage check in alt/reg/stater.If the whole system has gone south then back to alarm.Disconnect grd.at battery,reconnect grd alarm should go off,turn it off in usual way and check it
...Check for power from the stator while turning the engine over(If you have power continue down the list)Check coil (Check voltage input while turning engine over)(if no voltage continue down the ...
...signal fault ,and will usually be from an interrupted signal from your ignition coil which can give the code c24-c27. Check the coil,wiring/coupler connections and power supply from the
Question about Yamaha YZF-R6 Motorcycles
...check crank position sensor signal input at module. If crank sensor input is present, but module output isn't, replace the Ignition Control Module. hi.have you wiring diagram from xl 1200 1993?i ...
...power for a period of time. some suggestions are over heating problem in electrical somewhere and once it has cooled down then fires up. would the coil be the problem or other. regards grant I HAVE ...
...power wires and the usual suspects are: 1. Fouled spark plugs. 2. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary. 3. Check ...
Question about Yamaha YZF-R6 Motorcycles
the battery no voltage what do i look for next no voltage what next Check the lighting coil on the stator for power,check main fuses,check voltage regulator,Have the battery tested to insure it's good
...to the coils. If not, check your fuses and finally your ignition switch. Some small displacement motorcycles have magnetos to generate the power for the spark plugs and that may have become
151 questions posted
Usually answered in minutes!
288 Questions
115 Questions
98 Questions
99 Questions
108 Questions