Question about Triumph Trident 900 Motorcycles
not start it turns over back fires turns over and starts, sometimes starts second turn. has had new coils fitted tappets a Triumph trophy 900 carb 1997 starting problem. sometimes the bugger just will
triumph trident 900 been sat for a few yeas managed to get it going but only on 2 cylinders then turned it off and on again now there is no spark to any of the spark plugs,I have checked all ...
Question about Triumph Trident 900 Motorcycles
my 1996 trident 900.traveling to work the other morning the motor cut out for a split second then fired up again then stopped all apropreit lights were going would wind over but no go.I have checked ...
How do I check the ignition coil The bike will not start I checked for spark and there was none Ignition Coil Primary Circuit Test Remove the coil. THEN set your ohmmeter scale to RX1 and place ...
how to check for spark, harley springer Ignition Coil Primary Circuit Test Remove the coil. THEN set your ohmmeter scale to RX1 and place ohmmeter leads on the primary coil windings A (front of coil) ...
Question about Triumph Trident 900 Motorcycles
BIKE RAN GOOD BUT HAD BACK FIRE ONCE IN A WHILE REPLACED COIL RAN GOOD FOR 100 MILES SHUT IT OFF NOW HAVE NO SPARK TO PLUGS Could be an ignition module. Check the coil first. Check your pick-up sensor
1998 FLHT wont fire up engine turns over but wont't start up Are there any codes. Does it backfire? To start you need spark at the plugs, fuel in the induction module or tubes and compression in the ...
throttle cable install What year???? For some models and years, but do not know if it fits yours as I do not know what year you have: Ignition Coil Primary Circuit Test Remove the coil. THEN set your ...
...R thunder cat: only running on 2 cylinders... Only running on 2 cylinders probably a bad coil, the coils are set up #1 and #4 from one coil, and #2and #3 from the other. check to see if your get 12v ...
coil not firing Not firing through plugs Either your coils are bad, or they are not getting power, or they are not getting a signal from the pulse coils. Check ignition fuses Check for ~12V at coils ...
13 questions posted
Usually answered in minutes!
20 Questions
15 Questions
8 Questions
3 Questions