1997 Suzuki GSF 1200 Bandit S "throttle cable gets hot" Questions

gets hot, gas pours out of the fuel supply tube at the male/female connection between the fuel supply valve and the tube that leads to the carbs. The two symptoms seam to be linked to hot engine temps

...throttle cable. The other one didn't look too hot so decided to change them both. Took me a good few minutes to figure out how to thread the cable through the slide in the carbs but managed it in the ...

...throttle cable. The other one didn't look too hot so decided to change them both. Took me a good few minutes to figure out how to thread the cable through the slide in the carbs but managed it in the ...

...throttle cable. The other one didn't look too hot so decided to change them both. Took me a good few minutes to figure out how to thread the cable through the slide in the carbs but managed it in the ...

...throttle cable. The other one didn't look too hot so decided to change them both. Took me a good few minutes to figure out how to thread the cable through the slide in the carbs but managed it in the ...

...hot day to experience this problem. Riding around town, there are no issues (idles just above 1k), other than the bike takes a bit longer than I'd like to get warmed up. I have: Run sea foam through ...

the unit to the bars. and separate the holder, remove the cable end from the throttle rolling connection, put the cable end into the slot and re-attach it to the bars. No problem. They're all the same

...throttle Hi I have a 2002 cbr600fs sport which has been stud for 7 months without any use. When i have got round to getting it out and riding it started first time. The only problem is the revs stick ...

...throttle cable off the arm at the carb end and try pulling the cable and check 4 stiffness maybe a frayd cable other wise all air screws may not be in sync with each other if tht doesnt work get back ...

...throttle cable. The other one didn't look too hot so decided to change them both. Took me a good few minutes to figure out how to thread the cable through the slide in the carbs but managed it in the ...