2005 kawasaki KX 250 F "front forks" Questions

...front fork, what other years or brands will fit. Depending how badly they are bent, it may be straightened. By using a press it is possible to straighten the forks if they are not too badly bent. I ...

I have a 2005 KX 250 and Changed the front fork seals, we disassembled them and filled inner tube and bleed off excess and assembled then filled outter tube with 300cc of fluid and assembled, slapped ...

...there is a rebound, and compression screws on the shock you can turn them to the right to adjust this, the front forks have these adjustments also but you will not need the spanner wrench for

...forks changed....so the front calipers were removed and reintalled. After that, I changed the entire right clip-on with master cylinder. I'm tring to bleed the front brakes but not getting anywhere ...

...dampening and the other for adjusting the compression dampening of your rear shock.  The front has the same set up for each side of the fork.  (2 pistons in front and 1 in back).

...tape marked spoke. Next, tape a small piece of plastic(I use a zip-tie) to the L/H fork leg(for a front wheel) or the L/H side of the swing arm(for a rear wheel) so its nearly touching the rim. Now ...

...front forks on my 1999 Suzuki Marauder VZ800. FORK OIL ? Place the front fork vertically without spring. ? Compress it fully. ? Pour specified front fork oil up to the top level of the outer tube. ...

...Air shocks low on air. Any of those things COULD cause the front to bottom out. Probably the most likely is low oil in the forks. Not likely the damping mechanism could have failed but it's

...front forks i have a oil leak Your front fork seal are bad and need to be replaced. When you loose fork oil, your loosing suspension dampening and only riding on the springs.(POGO) Replace both front ...

...front forks on a 2002 Yamaha TTR 125 L Our 2002 Yamaha TTR 125L did a wheelie over a car and landed on the front wheel then fell on it's left side on the sidewalk. It still starts up with no problem, ...