...but i'm lost i don't know what to do and i don't want to take it somewhere. Hi you will need to remove the carb and clean it completely, pull all the jets out and blow through them, the jets are ...
Question about PGO Motorcycles
...remove plug wire +hold near earth, help pleae motors need three things to run. Fuel, Oxygen, and Ignition (spark). If you leave motorcycles set for a long time, the gas in the carburetor will turn to ...
Question about GAS Motorcycles
...to clean a motorcycle gas tank" find a couple forums to view the different options available. 2. Remove your air cleaner and clean and re-oil per Mfg. specifications. 3. Remove the carburetor, ...
...I would greatly appreciate them. Thanks Jeff Sounds like float,s sticking. Check float needle remover all plastic/ rubber parts then soak the whole carb body and slow jet in lacquer thinner the ...
...lacquer thinners is a better cleaner, used with a stiff brush. Do not use wire or hard objects to clean jets, slight scratching could destroy the orifice. If the throat or body exterior is stained, ...
...lacquer thinner inside the forks to remove the excess fork oil, but do not use paint thinner as it will damage the fork seals.hope this helps u please rate me....................... thank u for using ...
Question about kawasaki KLX 125 Motorcycles
...clip on needle to richen fuel here a carb manual.pdf that will give the basic principle of tuning remove any rubber, plastic parts an soak carb in lacquer thinner and use a copper brush remove ...
Question about kawasaki KLX 125 Motorcycles
...lacquer or acetone to thoroughly clean the oil out n then remove any raised edges where the chrome may have lifted above the surface(were talking microns) and any little flaking goes as well, then ...
36 questions posted
Usually answered in minutes!
32 Questions
17 Questions
1 Questions
1 Questions