...the wheel torque the axle nut to 80ft/lb. Do this by cutting a piece off the(long end) of the allen key and using this piece with a 14mm socket and torque wrench.(Or just buy a 14mm allen key
Remove the caliper unit from the disc, probably allen wrenches will be needed or at least metric wrenches 4) The pads will come out with a little of force and removing the retaining springs. Take note
...wrench. Use a 14-mm hex socket to unscrew the front caliper bolts, and a 6-mm Allen socket for the rear caliper. 2 Slide the caliper off the brake rotor. Suspend the caliper from the handlebars or ...
Question about kawasaki ZXR 750 Motorcycles
...allen wrench, move caliper and the swing arm up and away from the wheel. remove axle, jack the bike up and wiggle the tire to the right side and down, do not remove the final drive (learned this ...
...allen wrench and loosen the socket bolts but do not remove. Now unbolt the handle bars and rest on a towel (just move back out of the way, you should not need to unhook everything) Remove the air ...
Question about kawasaki ZXR 750 Motorcycles
...Allen Bolt back into base of slider as per originally was (Remeber to hold Threaded Bar if it starts spinning) Push Gently new Oil Seal into Fork Slider for Snug Fit. Be Gental. Replace Clip/Spring ...
...allen wrench on the floor and torque the dampener to the manual's specification. 11) Put the tube back in the bike. Torque pinch bolts. Pour 13 ounces of new fork oil into the tube. Work the lower ...
...Allen wrench is needed to loosen but do not remove the seat pipe screw, while the internal components are still under tension and less prone to rotate, on the right fork tube and slider assembly, ...
133 questions posted
Usually answered in minutes!
31 Questions
23 Questions
18 Questions
14 Questions
11 Questions