Craftsman 17.5 hp 42 in. Deck Lawn Tractor - CA Model "lt1000 mower remove" Questions

lt1000. You need to remove the black rubber cap from the center of the wheel. Remove the "C" clip from the axle and the wheel should come off. The rear tires will have a square key in it. Do not loose

...mower deck to my LT1000 Model 917-276393? I have purchased new parts from Sears and need to know how to put them on the mower. hello, just follow directions on the parts list,shouldn't be that ...

...LT1000 riding mower. I have purchased the shield but the rod that holds it on ( which is on the mower) is capped at both ends not allowing them to come out. How do I put the new shield on without ...

How do you check compression in lawn tractor? Craftsman lt1000 remove the spark plug screw in the gauge and crank it over with the throttle wide open and the choke off

Craftsman lt1000 stays engaged while lever in neutral linkage is sticking...remove key...and do a visual as well as physical inspection...and maybe a spray or two with wd-40 when problem is found..

mower has no power and backfires. LT1000 Sounds like it could be a broken flywheel key and your engine is slightly out of time.  You will need to remove the flywheel and check the key and replace

lt1000 17 hp . problem: starter will not turn engine past compression stroke. changed starter and bypassed switch and connected car battery to starter, same result. any sugestions. also spins fine ...

...remove gas tank from craftman LT1000 lawn tractor it is located under the seat Hello, removing this tank is easier then it may initially seem. Here are the basic steps: tilt the seat forward remove ...

lt1000 won't start Wont start First thing I do, see if you fuel.  Remove fuel line from carb.  Second check your choke.  See if  linkage moving enough.  Third it on ...

...LT1000 one blade locked up. What could be causing this? You must remove the belt. The blade is attached to a shaft assembly that has a bearing on the top. Check to see if one or both is not free to ...