...commutator bars flat. I also put medium grade sandpaper in-between the brushes, and the commutator surface to dress an arc on the brushes. (Turn the armature by hand while keeping the sandpaper in ...
The gx340 engine starts fine but runs for about 30sec.then quits as if ignition is cut.I've put fresh fuel in w/stablizer,then check plug and noticed very carboned up.So I put a new Champion equal in ...
...on the armature being cupped. To remove this you would have to use a commutator stone to clean the surface. I would recommend finding a repair shop. Also just a thought do the brushes move freely in ...
...the blade keeps falling off. Do you have the securing nut on the correct way? Basically the inner surface of the nut needs to be flat against the blade for it to work correctly and hold the cutting ...
...from drano and all that other ****. PVC is not cemented or glued together. A solvent melts the surface or the PVC and when the two pieces of PVC are put together and the PVC hardens they become ...
...wrench to my hitachi g12sr3 grinder. how do i remove the wheel? Place the grinder on a steady work surface and use a punch. So that you do not distort the nut find a punch that fits nicely into one ...
Question about Stihl Saws
I ran my ts420 with normal gas. Now it wont start. What messed up? How do i fix? it will be the pot and piston mate Not sure what a cooking device has to do with a cut-off saw, but your piston and ...
I have a 1986 Enco 6X18 Surface Grinder and it needs a Feed cable that drives the table left to right. Any idea on who would carry this? The serial # is 512205-31. Any information would be greatly ...
...make sure not sticking in the brush tube and also look at the commutator for a really dirty
2 questions posted
Usually answered in minutes!
41 Questions
40 Questions
20 Questions
14 Questions
