...control board & no place to plug the old piggyback board on the new main board. Anybody ran into this b4? The new board may have the actuator relays and connectors on the main board. If so plug ...
...control board. They asked me a couple of questions about the unit (to figure out which control board I needed), and sent me a control board at no charge. (Your mileage may vary.) Installation took ...
...control board. Bought one installed board, switch, thermometer control and temp sensor. All readings the same 500mg to control board from switch.Nothing coming out. I think wire coming out th to gas ...
...control board issues I have been told that I need a new main control board (not the display board) for H250PED2 do you know the part #? The heater fires up but only stays lit for a few seconds, ...
...control board and I get the same error. Please help so I don't have to pay a spa maintenance company. Thanks Its the top membrane where the control buttons are. The circuit board plugs in to
...Control board only shows green LED lights. Prior to not firing water temp was 120 degrees. Almost burnt my foot off. Next day heater did not fire at all. Where can I go to test control board? Live in ...
...iaqualink instead of your replacement board, it is backwards compatible, meaning all of your existing controllers will still work, but it gives you internet/iphone/android control capability as
...Control Board. 3. Confirmed 24VAC output from transformer. 4. It appears that the ignition control module has burn marks around the upper left where it attaches to the box and the bottom center 5-pin ...
...control board is failed? I have the actual control board pn 42001-0096, but the manual says this model number should have a part number 42002-007S which one is correct? Here is the link again to the ...
18 questions posted
Usually answered in minutes!
774 Questions
131 Questions
104 Questions
113 Questions
87 Questions
