...goes only up to 40 psi. I need atleast 75 to 110 PSI to use the nail gun that I recently purchased. What can I do to fix the problem does the compressor keep running all the time but never gets above ...
...40 psi. and keeps trying to pump air. Turned the psi knob up to maximum and still goes no where.. Please help Tank check valve Blown head gasket Bad Reed Valves Your choice,check them out. Either air ...
...goes up to 40 psi and dose not go any higher and on the other hand engine keeps running and dose not stop. Please advise? Thanks. Kia the pressure switch needs adjusting - need service book for that ...
...goes back together right. Use care cleaning the old gasket off, NO power tools....Hand wire brush to preserve the little ridges that bite into the gasket, Soak with solvent helps..You can also order ...
...40 PSI the other reads 60 PSI. Your problem is most likely because of damage to the valve plate or piston & cylinder. If one or both of these are not working properly you'll get partial ...
...goes to 40 lbs. any ideas these small compressors do not have a long life especialy if they are run for more than 15 min /hour , bet no body told you that when you bought it the ones with an iron ...
...goes in and then just runs out again and will not compress. If while running the air pressure in the tank comes up (watch the tank pressure guage) but then leaks out after the pressure ...
...goes up to about 40 psi and will not shut off. I have tried turning the adjusting knob all of the way both ways. I took the cover off of the pressure switch and turned both of those adjusting screws ...
Question about Stanley Air Tools & Compressors
...on the gauge if the pressure recorded is around 40 psi or less , replace the failed poppet/reed valves in the compressor head if it goes to 100 psi then replace the automatic controller for the ...
369 questions posted
Usually answered in minutes!
49 Questions
42 Questions
38 Questions