Nordic Track T5ZI Treadmill Walking Deck "motor wiring" Questions

where do I screw wires on key fitness drive motor I replaced the bearings inside the drive motor, but can't remember where the wires connect beside the fan part on the drive motor. I am especially ...

e2 error on pro form 730 key in belt and motor run about 5 sec and shuts down sensor light blinks but not a steady light Dear Sir: I will try to help you, use the patience and carefully: need ...

motor wiring is damaged or has intermittent connection. 3. Gear motor is bad. 4. Gear motor target is damaged. 5. Lower PCA is bad. Corrective Action Disconnect power from the unit. Remove the F2 fuse

...motor control board. Also check the main wiring harness from the console to the lower motor controller to determine if a wire has been cut, pinched or shorted to ground. If all wiring is in perfect ...

...wiring diagram Key in set program(manual) motor and belt run and move for 5 sec. then shows e2 error Dear Sir: I will try to help you, please be patience and carefully, use basics tools:screwdriver, ...

...motor control wiring D) Worn or faulty motor brushes E) Faulty pwm/relay combo board or faulty drive motor Corrective Action A) Enter Open Loop Speed mode and set treadmill speed to confirm proper ...

...wiring from the lower controller to the lift motor. Be sure to check the condition of the lift motor as well as the wires entering the lift motor. Sometimes the wires will pull away from the plastic ...

...screen says error have tried restarting, looked for a reset button Unplug the treadmill. Remove motor cover . Look for the incline motor, follow the wires coming from the incline motor to the ...

...wiring diagrams that shows wire colors. I have the motor wires connected black to black and red to red. The power leads Black/red will determine the direction that the motor will turn. If the leads ...

...wiring issue between your board and the incline motor, or the board itself is faulty, but then that's beyond my knowledge of this particular problem. Don't worry though, with what I've ...