I changing my car battery I put disstilled water ang I charge after 5 hours my baterry was same voltages when firts I cheked how know to if my baterry need to replace and how to know if my baterry are
...in the drivers. Disconnect the positive and negative voltages to the output and see if the protect changes. Even a fault in the preamp stages that drives in high current into the output can shut the ...
change them. These items can be pruchased from any electronic spares parts shop. After the job is done before you power please check the following: Disconnect the positive and negative voltages to the
...store electricity and deliver it quickly to your amps as needed. Capacitors resist voltage changes by producing large amounts of amperage. This means that the capacitor(s) will provide the ...
i got an alpine apx 1300 300w and the protection light is turned on Most likely there is a short in the output stage. This would mean changing the output IC's and most likely the damaged support ...
...voltage is staying low on my battery first you dont bridge both ,, 2nd you will need to find out what ohms your speakers are , and if dual coil what ohms each coil is ,, then find out what ohms your ...
...seconds then go to regular mode then again in about 20 seconds will do the same thing. Nothing has changed in three years with the wiring. I thought maybe it was a voltage issue to I did install a ...
...change what product brand did you install. do you set the amps x-over and gains a sub sonic filter right need to see if the amp is on check led light on amp. make sure your subs ohm load is correct ...
...in the drivers. Disconnect the positive and negative voltages to the output and see if the protect changes. Even a fault in the preamp stages that drives in high current into the output can shut the ...
52 questions posted
Usually answered in minutes!
196 Questions
131 Questions
85 Questions
67 Questions
48 Questions