Question about Toyota Camry Solara
...high beams and fog lights do not work. Low beams, blinkers work fine. I have replaced the headlights relay, the fuses, checked the bulbs, and inspected the blinker switch not a blinker switch expert, ...
...low beam relay and the high beam relay in the underhood fuse block. When low beam headlamps are requested, the body control module (BCM) supplies ground to the coil side of the low beam relay. This ...
Question about Saturn Cars & Trucks
...low beam relay and the high beam relay in the underhood fuse block. When low beam headlamps are requested, the body control module (BCM) supplies ground to the coil side of the low beam relay. This ...
...low and high beam relays in the fusebox and there was no change...no low, high OK. I can feel the low beam relay click when turning on the low beams and then the high beam relay click when turning on ...
Question about Toyota Camry Solara
...high or low beam . Any ideas? Do you know how to test electrical circuit's using a wiring diagram an a voltmeter ? Reading how the headlamps are suppose to work ,then testing is how to find the ...
...high beam/low beam switch and to the low beam relay. The relay for the low beam is located in the battery junction box (BJB) in the engine compartment. If the high beam/low beam switch is set to "low ...
...beam to low beam lights. You should feel a click in the relay when they make the switch from high to low beam. If not replace the relay and the problem should go away. Hope this will help you. ...
Question about Toyota Camry Solara
...high and low beam lights use the same power source, so if the low beams work the high beams have power.There is a low and high beam relay controlled by the dimmer switch.If the low beams work and the ...
...one for your high beams. check for that and then if high beams are working swap it with low beam relay. if your problem switches to low beams working and high beams not working replace the bad
Question about Cars & Trucks
...low and high beams out, new bulbs, fuses good. No power at the sockets. Could this be the high/low switch on the column? It shouldn't be the high/low beam switch, as that switches the high/low beam ...
239 questions posted
Usually answered in minutes!
230 Questions
213 Questions
105 Questions
58 Questions
154 Questions