...180 degrees out piston 1 and 4 are up at the same time,so if the timing chain is on the marks , pistons should not hit the valves,I think the timing chain was out one or more teth the first time you ...
...180 degrees out of alignment with the timing. If you only took out the cap, refer to your owners manual (Hanes is best) for the plug wire placement in reference to the firing order, and make sure all ...
...180 degrees off. Align the timing mark on the crankshaft then check the rotor position.If it doesn't point to number one wire terminal position roll the engine over until the crank lines up to the ...
Question about Toyota Pickup
...180 degrees off. Once you get the engine started, you would use a timing light to set base timing. 24Z nissan engine, it should have some colored links as in silver , one will match the cam mark wich ...
180 degrees out of time. we set it four times That's impossible ..... Are you sure the number 1 cylinder is at top dead center should be first one on passenger side of car....and I'm not 100% sure but
...timing setting for 1998 Dodge Ram 1500 Put the number one piston at TDC (top dead center) Pull the cover off the distributor and check to see if the rotor is pointed at the number 1 plug wire. If not ...
Question about Nissan Cars & Trucks
...timing marks on pulley are about 180 degrees off engine starts and runs Which pulley is 180 degrees out? Crank or Cam? The Crank shaft turns twice for every one turn of the camshaft so you could have ...
...timing light for final set. If it wont start you got it on 180 degrees out then just move the HT wires around 180 degrees. If you have a transistorized ignition then when the point of the cam star is ...
timing setting Must the number 1 piston be on top to set the timing by the distrubutor No it should not make a differance considering the engine will be constantly rotating, because the engine must be
Question about Cars & Trucks
setting the valve timing on the induction stroke and you will need to turn the engine 180 degrees to compression stroke for the pump timing marks to line up. the injection mark on the flywheel is what
626 questions posted
Usually answered in minutes!
914 Questions
745 Questions
525 Questions
407 Questions
140 Questions