1991 Toyota Corolla "4 camshaft timing marks" Questions

...indent on the front camshaft bearing cap. The approximate correct oposition of the camshaft gear is also indicated by the No. 4 Cylinder exhaust valves just closing and the inlet valves just

4-door sedan are there alignment marks to get the cams back "in-time" or is there a trick to it? If you removed the timing belt to fit the new water pump then you have to reset the timing on camshafts

4 cylinders after changing timing chain with out moving TDC before removing old timing chain and gears. Have fuel and spark on all four plugs. no blown head gasket or broken rod or crankshaft. You can

...4 holes in front of the gears. Front being closest to timing belt. Upon installation one hole in each gear should face upwards and the other holes should face each other between the gears. On the ...

...4 bolts and the cylinder head shield (XRS). Remove the 2 nuts, bolt and remove the ventilation hose from the ventilation pipe (XRS). XRS Remove the Ventilation pipe and gasket (XRS). Remove the 9 ...

...4 align crankshaft and cam shaft. removal of crankshaft pulley may be necessary. remove #1 spark plug and plug hole with finger , have assistant rotate crankshaft until pressure is felt on finger. ...

...4, 6, 7 and 8. Nine Method I've never really gotten into doing this, takes too much time and maths for my liking :P Rotate the engine through its' range of movement, as one valve is "on the rock" of ...

camshaft with a wrench, then remove the bolt and timing pulley. Be careful not to damage the cylinder head with the wrench To install: Check the idler pulley by holding it in your hand and spinning it

4. Do Not let the silicone skin-over before setting the valve cover into place and tightening the bolts, also be sure that both mating surfaces of the valve cover are clean and oil free . 5. After the

...4. RH Bank Intake Camshaft Timing Gear 2 1 1 Bearing Cap Timing Mark 2 Gear Timing Mark © 2008 Toyota Motor Sales, USA T-SB-0291-08 September 11, 2008 Page 4 of 5 2GR-FE Valve Timing Procedure ...