...Remove the door trim panel and watershield. Detach the motor wires at the multiple connector. Remove the motor retaining screws using Torx® drive bit set D79P?2100?T or equivalent, and separate ...
...Remove door trim panel and watershield. Refer to Section 01-05 . Check all connections of remote control links and cables. Service as necessary. Remove remote control assembly. Remove door latch ...
remove the door trim panel to access the door ajar switch. Remove the door open warning switch by turning it counterclockwise. -------------------------------------------------------------------------
getting to power window controls on driver door Remove door screws and remove door panel. you will see connections and than remove control panel and when removing have somone hokd window or it
Question about Lincoln Continental
...remove the door panel. You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips ...
...remove rear door panel on 2001 continental? I removed two screws in door close handle..then what? Need to replace the window motor and dont want to tear up panel You'll need to remove screws that are ...
...door panel. the remove the screw behind the door opening latch. 2. disconnect any powe windows/ power locks. 3.carefully "wiggle the door panel off(you will have to look closely where it connects to ...
Question about Lincoln Continental
...door actuator. Remove the A/C air intake flue damper assist spring (19917). CAUTION: Do not attempt to bend any part of the A/C damper door shaft (19A580). It is brittle and will break. Depress the ...
Question about Lincoln Continental
...Remove A/C electronic blend door actuator electrical connector. Remove three remaining retaining screws from A/C electronic blend door actuator. Pull the A/C electronic blend door actuator away from ...
Question about Lincoln Continental
...remove the door panel as the bolts holding on the mirror are on the inside. roll down the window.,as the door panel has to come up and out. This is easier done with the window down especially for ...
890 questions posted
Usually answered in minutes!
440 Questions
386 Questions
297 Questions
273 Questions
234 Questions