Question about Chrysler Pacifica
...ignition switch, but bells still keep going off after i open the doors i had replaced the ignition switch in my 2008 pacifica, i shut car off and remove keys but when i open the doors the bells will ...
ignition switch Key will turn in the ignition switch but no spring action to bring it back to the run position and turning to start will not cause the starter to engage. This morning when I pulled the
ignition key won t come out i replaced starter not the problem replaced starter relay switch not the problem found out the neutral safety switch was bad not the problem it was the ground to that part ...
Question about Chrysler Pacifica
...ignition switch The sparks when you disconnect the battery indicates there is a current draw. This is normal because all the computers store memory info - you would need to actually measure the total ...
Question about Chrysler Pacifica
...ignition switch but the key won't come out after the car is turned off. is there a button to release it? and if so, where is it located? slam it into park,sounds like shift interlock is hanging up or ...
...part way. it will not turn far enigh to start the car. it just locks up. some times it will start if i turn it fast and hard. help!!!! thank you!!!! replace the ignition switch problem is in the ...
Question about Chrysler Pacifica
...ignition switch in the "RUN" position check for Battery voltage at the Accessory Relay Output terminal of the harness connector. If OK , go to Step 6. If not OK repair the Accessory Relay Output ...
ignition switch itself. You need to verify that the battery has 12v first and that it can pass a load test. then check for power at the relay and starter trigger wire. (check with a volt meter) I hate
Ignition coil and a couple of other parts...now the vehicle has been put on a diagnostic machine and they have said that it is the main computer??...could you tell me what the part is called and is it
ignition switch is in the OFF position. If after performing the hard reset functions of the right door switches return perform the Repair Procedure. PARTS REQUIRED: REPAIR PROCEDURE: 1. Disconnect the
1,661 questions posted
Usually answered in minutes!
1,141 Questions
504 Questions
133 Questions
44 Questions
36 Questions