1993 Mercury Grand Marquis "not crank" Questions

...not always crank right away when I turn the key on. When I turned the key on there was a hesitation before it cranked over. The hesitation period starting getting longer. Now it will not crank the ...

car wont start my car cranks and cranks and wont start, plugged in my scanner and it does not power on, it works on all my other cars so i know its not the scanner. had it towed to shop they said to ...

...crank but never runs i already change the feul pump and filter it still isnt cranking Nothing to do with fuel/filter, either the battery or starter is at fault ,if it does not cranck over, if the ...

...it off and try to start it again it will crank but wont stay crunk. whats wrong with it? probably it is your crank shaft sensor when it is cold it expands and when it gets hot it is not making ...

...it has good fuel pressure and fire from wires and plugs but wont crank up How about the injector? In the engine junction fuse box the fuse for the injector power is in there make sure its not ...

...not repaired, asap. Hopefully your crank shaft is in good condition, and the culprit will turn out to be just a simple loose pulley bolt. The repair cost could catapult to a higher rate if it turns ...

crank is now worn down and there will not be adequate sizing for the interference fit.. If you clean up the crank, and use loctite red on the pully and crank surfaces making sure the bolt is tightened

...not get above 40 and it was hard to accelerate. I probably drove it another 4 times until it stalled while I was driving. Now it wont even crank. I hear the fuel pump prime also. maybe bad cpu or ...

not continue to crank or run. With my pump motor winding open, the Power Control Module may not have been loaded properly to function (reading +6.5 floating volts instead) in the key "on" position and

...not crank at all car has a new battery there is light in side doors open and closed but will not crank at all.. first of all check to make sure the engine is not locked up but placing a socket wrench ...