1995 Mercury Sable "rear sprocket slips" Questions

Rear window electric motor will not lift window. I have examined the motor; but upon reinstalling, it still will not lift the window, as if the sprocket slips. What do you recommend? First find out if

...rear cover. Slide the sprocket and chain on the shafts, maintaining the proper alignment shown in the accompanying figure. While installing note the following: Make sure the rubber and tension blade ...

Sprocket , Rear Removal Drain the cooling system. Refer to Section 03-03 for the procedure. Disconnect the battery ground cable (14301) . Remove the generator drive belt, water pump and power steering

rear camshaft sprocket first. Install a binder clip on the belt to the sprocket so it won't slip out of position. Keeping the belt taut, install it under the water pump pulley and around the front

...sprocket back to the marks so I can continue with the timing belt replacement? Gee, Ray- If you're reading this now, I hope you had a way to solve this, since this is December and you wrote this ...

sprocket bolts and do not rotate the crankshaft counterclockwise. Also, don't turn the crankshaft or camshafts after the timing belt has been removed. Position the number one piston at Top Dead Center

rear camshaft sprocket and the timing chain/belt tensioner. NOTE: An assistant may be needed to adjust the timing chain/belt. While holding the timing chain/belt tensioner steady with an Allen wrench,

...sprocket. Remove the rear timing cover stud. Remove the heater return tube hose connection at the water pump inlet tube. Remove the water pump inlet tube fasteners and the inlet tube and gasket. ...

...rear sprocket. If you can pull it away from the sprocket and see a fair amount of space between the teeth, replace the chain. Also both sprockets at the same time. Repost another question if more ...

...marks. On the crankshaft pulley there are two pairs of grooves. Align the second pair with the rear of a bump on the bottom of the oil sump. The two camshaft need alingning. Open the cylinder ...