1992 Audi 80 "correct ohm reading spark plug" Questions

Ad

...ohm meter and measure the terminal at the cold start valve after disconnecting the wire harness. The meter should read 25 ohms. If it doesn't replace the cold start valve. try a HOTTER spark plug. ...

Ad

Question about Audi 80

1 Answer

...ohm reading except the front sensor on the block above the heat sensor. i replaced all the spark plugs. the car gives an airbag fault when i turn the ignition on. An ohm reading is good but what you ...

Ad

...spark plug wires for proper orientation. With the ignition OFF, remove the fuel pump relay. Crank the engine and test for a strong spark on each cylinder spark plug wire using a suitable spark plug ...

reading of 12.94 which is the correct voltage for the coil. Need to unplug the electrical connection not the plug wire and measure the resistance there and see if you have the 9 ohms of resistance. If

...Ohm. If it reads infinite (open), the internal resistor is bad. If the plug is worn or the gap is too large, correct that. If it is fouled, you need to investigate and remedy the cause of the ...

Question about Audi 80

2 Answers

...correct. Remove the coil HT cable from the distributor, hold I/2 inch from engine block while engine cranking spark should jump this gap, if so coil and cable ok, remove distributor cap, place coil ...

...correct clys, nothing shorting out.. New TPS, new IAC, newTPS, all have new pigtails including new DPFE , new pigtail also. EGR good,all new 02 sensors. All have power going to all of them, New ...

...ohm meter on the primary side. but can be on the secondary you do know how to test wasted spark , right, All spark plugs must be attached and grounded for the coil to work, 1and 4 are shared. 2 and 3 ...

reading with ohm meter and see if your has the same resistance good luck and let me know what you didn'tdidn't It could be the ignition module (igniter) and it could be a bad connection to the igniter

...ohm reading, example 14.8 - 16.8. To much fuel will flood the firing and cause a misfire. you have already replaced the plug and the ignition wire so the only thing left would be the injector. One ...

Not finding what you are looking for?
1992 Audi 80 Logo

207 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1991 Audi 80
1991 Audi 80

45 Questions

1993 Audi 80
1993 Audi 80

11 Questions

1990 Audi 80
1990 Audi 80

7 Questions

1988 Audi 80
1988 Audi 80

45 Questions

1989 Audi 80
1989 Audi 80

42 Questions

Top Audi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...