...test the code is 1345 but i dont know which sensor i need to change maybe can you help me Definition of Diagnostic Trouble Code P1345 Audi: Ignition Coil Power Output Stage 3 Short to Ground BMW: ...
Question about Chrysler Sebring
Problem battery goes dead after sitting. Did some testing that led me to lights , possibly dimmer or multi-function switch maybe ignition switch. Did some testing that led me to lights, possibly ...
...variable power supply to test movement of the valve. I could not see any movement in the valve while changing the voltage from 0-12 VDC. It was also initially set to about 1/16" open and I forced it ...
Question about Cars & Trucks
...definition. Cost would depend on your area and the actual problem found after testing. P1800 NISSAN Description When the engine is running at low or medium speed, the power valve is fully closed. ...
The lights on my 2005 Chyrsler 300 go dim bright,dim bright My brothers Chrysler 300 Limited with the 3.5l had the same problems. On cold starts every electrical component would dim in and out which ...
Question about Chrysler Sebring
...can test by pulling it out and hooking it up to a variable 12v power supply. If it works without fail when it is removed then it is going to be the control panel switch and will need to replace
...every 100,000 miles Can't have any Vacuum Leaks -- anywhere on the vehicle Need to have it road tested with a Professional Scan Tool & look at all data & get caught up on Preventative ...
...test-except the light is still on). They cleared the light twice and it stays off as long as the car was running, but as soon as it was shut off and then restarted, the light came back on, instantly. ...
Question about Chrysler Sebring
...variable delay interval between the wipe cycles. The DELAY interval is controlled through a series of resistors within the wiper / washer switch. Park Position Operation When the windshield wiper / ...
... P1146, P1149 codes and three cylinder misfire codes for cylinders #1,#3 & #5. They did all kind of tests and found that this is due to bad ECU. Can ECU go bad and supply wrong variables wich causes ...
1,852 questions posted
Usually answered in minutes!
965 Questions
801 Questions
581 Questions
462 Questions
523 Questions