1997 Chrysler Sebring "change plugs wires" Questions

...plugs. As I removed the front plug wires, they all had oil dripping off of the plug wire and as I looked in the hole the wire came out of, it seemed to have oil in it and I could not see the actual ...

i have a sebring 2004 v6 2.7 which is misfiring. put it a new coil and changed plug on cylinder that doesnt fire still no spark. im getting power all th way to the plug tested with volt meter.it reads

...up it runs perfect, all this started when distriputor was changed Did you change plugs & wires when distributor was changed? Changing distributor might have amplified an existing problem

Replace the sparks plug and wires and now the car cranks but does not start if it ran before you change plugs and wires,you need to recheck your work.

...change. Like cyl balance test has 180 lbs compression on all cyl's. Proper fuel pressure, spark on all 4 cyl's. Have changed plugs, wires, & coils. Swapped dead cyl #1 injector with good running cyl ...

...change plugs and wires 1997 sebring Spark Plugs A typical spark plug consists of a metal shell surrounding a ceramic insulator. A metal electrode extends downward through the center of the insulator ...

...with a 2001 you shouldn't have to change timing, If it is off then either your CPS (crankshaft positioning sensor) is bad or your coil pack is ( the non- spark plug end of your spark plug

plugs and wires to discover #2 plug was all corroded,should we replace the power pack censor seems to be working each time we replaced it I would replace all plugs first and see how it runs. If it has

plugs are located on a 1998 sebring convertible jx 6 cylinder? I need to change them but cannot find them. Just follow the spark plug wires my man. Three to front (radiator side) and three to the rear

...Change your spark plug wires. Insulation breaks down and allows voltage to leak to ground. Make sure to route the wires same as original. Quick check is to spray WD 40 on the wires when wet as it ...