2000 Jeep Grand Cherokee "2 rod bearing" Questions

Ad

Question about Jeep Grand Cherokee

1 Answer

2 sounds can be connected also. i dont know really what to do with lil money to do much? any ideas on what my problem is and suggestions on what i should do now? You are right about the connecting rod

Ad

...2 times. Oil and filter just changed. Problem still exist. Direct reading of oil pressure at engine reads between 40 and 60 depending on rpm. Replace the oil pressure sending unit its giveing a false ...

Ad

Question about Jeep Grand Cherokee

1 Answer

...rod bearing caps any soiutions No special tools needed to tear down the D30 other than a 13mm 12 point socket to remove the hubs and a punch to remove the cross shaft pin in the carrier if you're ...

Question about Jeep Grand Cherokee

1 Answer

rod end free so ti's easier to work on but it's not mandatory. Once you have done that you will find three twelve point bolts on the back of the steering knuckle. Loosen them each about 1/2" and using

Question about Jeep Grand Cherokee

1 Answer

...2 PLUGED OIL PASSAGES IN THE ENGINE 3 BAD OR FAULTY OIL PUMP 4 ROD BEARINGS OR CAM BEARINGS EXCESIVE WARE IF YOU HAPPEN TO DO ALOT OF HARD STARTS (FLOORING THE GAS PEDDLE) THINGS LIKE THIS HAPPEN TO ...

Question about Jeep Grand Cherokee

1 Answer

...rod end to get access but I didn't have that problem & I looked at your bearing, it looks identical. Cost: That's really tough since everyone wants to make their weeks payroll on whatever ...

Question about Jeep Grand Cherokee

1 Answer

...rod bear.,valve job,rad. & water pump and transmission. now just shut down in middle of highway when accelerating or slowing down. engine light now on. whats up? COMMON PROBLEMS There are several ...

Question about Jeep Grand Cherokee

1 Answer

...2 before) the PO, ran water for antifreeze this cause the internal freeze plugs to pop and water in oil and rear rod spun(seized) water makes really poor oil substitute. when you take it down there ...

Question about Jeep Grand Cherokee

3 Answers

...rod end. See picture below. There are 2 ball joints on the right side--one in front and one in back of the axle. Once the boot is split, dirt enters the joint and begins to wear it rapidly. Have the ...

Question about Jeep Grand Cherokee

2 Answers

...rod a bad strut or a wheel bearing. you can inspect these things by 1: while in park turn the wheel from side to side while you have someone inspecting looking for things that are loose 2: jackup the ...

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

4,475 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...