...the upper strut mounts if it is the mounts that are making noise, some times its also the lower ball joints squeeking from a lack of grease normally because the ball joints are sealed and ...
Had ball joints and tie rods replaced. Now what? Check your cv shaft for play or broke cv boot. It could be the grease is gone and the joint is making noise or the wheel bearing hub could also be bad
...myself that disconnecting the steering knuckle from the strut ,removing the tie rod and the lower ball joint also from the steering knuckle and remove it so that its out of the way.This makes it ...
front ent has bounce at speeds below 60 check your struts and your upper and lower ball joints
...clicking or popping sound coming from the passenger front end? ball joints going out or CV shafts needing changed? Bad CV Half shaft on right hand side.Replace axle shaft assembly to cure
front wheelbearing replacement Wheel, Brake rotor and caliper need to be removed. Lower ball joint needs to be poped loose to allow CV half shaft to be removed. There should be 3 bolts on the inside ...
the wheel to feel like it needs a little muscle to turn the wheel. Have your tires re-balanced and the alignment checked. Your service professional should also inspect the ball joints and tie-rod ends
...the spindle. The spindle is attached to the strut with a coil spring. Also the spindle has a lower ball joint pressed into it and a streeing tie rod which attaches to the steerings rack & pinion ...
...ball joints,and bearing hubs. is there an adjustment to tighten slop in the rack and pinion? Unless your entire rack is loose, there's nothing you can tighten, but it sounds like you have a wheel ...
...ball joints, and especially tie rods. be prepared for the struts($300-450 depending on where youre at) and a really good idea to have an alignment done at the same time. cheers To check your struts, ...
333 questions posted
Usually answered in minutes!
757 Questions
631 Questions
489 Questions
420 Questions
426 Questions