...shudder and loose gears I have a Nissan Almera Tino 1.8 SE2 2001 model. I took the vehicle in to have the clutch replaced. When I received the vehicle back the gears felt really loose and the clutch ...
Question about Nissan Altima
...shudder jerking is it transmission not sure because if trans you'd think it would still engage and raise rpms even if it didn't go anywhere or a fuse out messing with the tcm or is all this caused by ...
Question about Cars & Trucks
shudder when pulling away and in between gear shifting. Please help Did you put in a rebuilt clutch or a brand new one? Shudder is usually weak clutch disc torsion springs. Rebuilt discs may have weak
...shudder whenever I pulled away in 1st gear. I took the vehicle back to the garage who said that there was nothing wrong with the clutch and that there was nothing that they could do!! Please help as ...
pulling away, in all lower gears. Then when stopped in traffic light it stalls and cuts out or shudders and only moves with a lot of heavy coaxing. It sounds like there could be 2 possible problems. 1
...away when the brake pedal is pressed slightly to unlock converter. Have a shop verify line pressure, and provided no valves in the TCC hydraulic circuit are worn, replace the torque converter. Also, ...
...pulling. does not start until engine is warm. it starts around 1100-1300 rpm. A faulty O2 sensor was replaced and greatly decreased but gradually started up again. can't be sure if it occurs when ...
shudder when you turn left or right from a dead stop, if you go straight it does not do it. It feels like it is in rear end but probably isn't. The transmission fluid is upossed to be a lifetime fluid
911 questions posted
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,306 Questions
534 Questions
410 Questions