1999 Ford Windstar "hot wire 2003" Questions

Ad

Question about Ford Windstar

1 Answer

...do I find it and how do I get a wiring diagram for Ford 2000 Windstar? Please help! You may have to run another hot wire from the back of the alternator to the battery direct. Use 10 or 8 guage

Ad

...hot air. The blend door act. works properly(We have already tested it). There are properly freon in the Vehicle. We are at a lost. Please help Can you tell if compressor clutch is engaged? If clutch ...

Ad

...(ground wire) from the bulb to any metal in the car, use the other (positive end attached to the bulb) as a probe. Probe each plug going into the radio, when the bulb lights, you found a hot

2003 windstar motor icon flashes while driving and engine runs rough then runs smooth again. Gives code po302 , po171, po174, po156. Have done tune up, replaced oxy sensor, coil pack, wiring harness, ...

...along with the hot wire to see if each of these lights works. If it does, trace the ground wire back to the frame, unscrew it and clean up the metal with emery cloth so you reestablish a good

2003 Ford Windstar. The windshield fluid dispenses, but not the back. Any idea why? Thanks in advance! Tim Yes a shop is usually great advice with this but heres some things you can do yourself. first

Question about Ford Windstar

2 Answers

...bright , pull your fuses one at a time until the light dims , thats the circiut thats killing your battery. yes,you have a dead short,hot wire grounded somewhere or lights staying on when key is ...

...wire boots will liquefy and run down the plug from a running hot motor====instant misfire (d) cracked insulator on the plug (porcelain white part)====instant misfire(e) plug wire insulation is burned ...

...hot. This will have to be replaced. This is the solenoid that works the OD lock-up clutch in the tranny Two things that it could be. 1 - Look under the hood, there is a wire coming out of the master ...

Question about Ford Windstar

2 Answers

...the wires melted. Check where the wires melted as the wire insulation may have failed or been pinched causing the hot wire to touch another, possible, ground wire. Please rate this answer,

Not finding what you are looking for?
1999 Ford Windstar Logo

1,790 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Windstar
1998 Ford Windstar

1,830 Questions

2001 Ford Windstar
2001 Ford Windstar

1,838 Questions

2000 Ford Windstar
2000 Ford Windstar

1,503 Questions

2003 Ford Windstar
2003 Ford Windstar

1,032 Questions

1996 Ford Windstar
1996 Ford Windstar

600 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...