1991 Ford F150 "302 spark plug wire" Questions

...302 I need a spark plug wire placement diagram for 91 ford f150 302 here is a diagram, if u can't see it go to the link below. http://autorepair.about.com/library/firing_orders/bl-fo-9225.htm ...

302 . under a load starts to shake like its loosing couple of jugs. pulled spark plugs they were white like its running lean. fuel preasure is 38 psi running. can you help renew plugs and high tension

...i have a 83 ford f150 4 wheel drive 302 v8. check and see if is getting any spark out of the #1spark plug wire .if not change out your distributor cap ,rotor button and spark plugs wires ,and ...

...302)that starts & cruises fine but wants to fall flat on acceleration. Any ideas? If when you try to accelerate, it seems to run more rough, it could be the spark plug wires. After time, these ...

...spark plug wires on a ford 302 motor FIRING ORDERS NOTE: To avoid confusion, remove and tag the spark plug wires one at a time, for replacement. If a distributor is not keyed for installation with ...

...302 motor when its set for top dead center Ok, If you know which tower the no.1 plug wire is in, set the distributor to that tower on the cap. Rotate the distributor withe the cap on and key on , ...

...302 which way does the rotor button face if your piston is up If # 1 cylinder is on compression stroke and at TDC, the ignition rotor should be pointing at the tab inside cap for # 1 spark plug wire. ...

...302 5.0L V8 4x4 pick up which included s[ark plugs and wires, cap and rotor, oil change, new oil and air filters...now it is riding rougher and worse gas mileage than before? what did i do wrong? did ...

...302 auto idles and revs great but bucks when speeding up going down the road does it only happen when you are accelerating or does it continue at cruise speed also? It sounds like you have defective ...

...302 and it have 5.0and I have spark going from the coil to the distributor then spark from the distributor to the wires going to spark plugs I have sparkand then I got a distributor from a junkyard ...