2001 Dodge Intrepid "change drive belt chrysler" Questions

...problem was, or the year of the car My guess is that the steering rack has worn out from no fluid changes every 3 years, since the car was new, & normal internal wear You HAD the rack LOOKED ...

drive belt?I can't figure out yet in short of getting a manual on how to do this,on fords you losen the tensioner,on this one(Intrepid 2.7)the tensioner is on the accessory belt side! so please if you

...change our spark plugs and the converters may be plugged but we didn't think it could be that because the car ran for a while afterwards. We also tried changing the cam sensor. The car would run ...

...drive it. If your driving it, it won't stop, just when you park it and shut it off. Then it won't start. check,change starter and alternator, crankshaft sensor if not first. the cam sensor will also ...

...under extreme conditions, such as in excessively hot or humid weather, dusty environments, or racing or emergency vehicle operations. On 2004 Chrysler Serbing to change the timing belt at

...change the timing belt on my 2000 Chrysler Sebring Convertible? Your engine should be a 2.5L V-6, Chrysler recommends timing belt replacement every 60,000, also timing belt drives the water pump, not ...

...drive the vehicle for years to come and the belt has never been changed before, then I suggest changing it as well as all the pulley's and the belt tensioner. I see you live in the St Charles Area if ...

change timing belt on a 2000 sebring lxi 2.5 Every 50,000 miles or every 4 years, whichever comes first. The timing belt should be changed every 60,000 miles on the 2000 Chrysler 2.5 Liter V6. This is

Drive Belts 2... How to Change Serpentine Belt on 2002 Chrysler Sebring http://www.serpentinebeltdiagram.com/serpentine-belt-diagram-2001-chrysler-sebring-4-cylinder-24-liter-engine-alternator-and-air

come on the dash board, even tough you have the seat belt on, what am I to do? sensor on the seat belt fastener bad. Wiggle it to make it go off with the seat belt locked in place or change the sensor