1994 Ford Ranger Supercab "slide hammer" Questions

Ad

Does the drum slide off of the studds on you rear right side of on a 1994 ford ranger yes it does. Sometimes they are rusted onto the axle. strike the drum with a hammer to loosen it up.

Ad

Question about Ford Ranger

1 Answer

...slide in onto the head of the stuck drive shaft. use something soft like a old wooden broom handle then knock out using hammer. ford have used simple spring clips to keep there drive shafts in and ...

Ad

Question about Ford Ranger

2 Answers

...turn the little gear a little bit at a time, and try to put the new drum on. once the new drum slides one the shoes, (it should take a little effort to get them on) spin them a few times and ...

...hammer to separate the dust cap around the edge. Work little by little around the edge to pop off the cap. 2. Remove the cotter pin from the end of the spindle and take the spindle nut off. You ...

...slide it on the spindle. Install the washer, this will most likely have a tab on it to align the spindle, make sure the washer is on correctly. Now you are going to reinstall the nut but only hand ...

Question about Ford Ranger

1 Answer

slide hammer can be rented from many auto stores. Drill small hole in center of plus and using the screw end on the slide hammer screw in drilled hole. The hole drilled should ne smaller than the srew

how to use a slide hammer to remove a stuck hub how to use a slide hammer to remove a stuck rear hub assembly on a 2003 Toyota Corolla MOUNT THE SLIDE HAMMER IN THE BOLT HOLE AND PULL OFF GENTLY

... There is a special bearing removal tool that attaches to a slide hammer. Insert tool thru center of bearing and use slide hammer to pull out. Use old bearing against new bearing and tap in with ...

Question about Ford Ranger

1 Answer

...slide hammer, Wiz Wheel type rotary cut off tool, chisel, ball pein hammer, hydraulic press, bech vice First you must remove the rear wheels, then you must remove the brake capiler and mounting ...

slide hammer is a tool made for this purpose, but you still have to separate the transmission from the engine. The slide hammer is a couple feet long and has to go along where the input shaft would be

Not finding what you are looking for?
1994 Ford Ranger Supercab Logo

891 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...