Question about Cars & Trucks
...button is pushed blowing high the display turns off but the unit continues to blow sounds like a blower motor resistor or bad relay. Blower motor resistor is so you don't burn up the blower
Question about Ford F-250
blower motors will kill the resistor. follow the water tubes from under the drivers side of van to the point where they enter the van, that is where unit would be located on the inside. be prepared to
...unit may need to be lubed if hard to turn or seized if seized and oil/lube not working replace blower the blower motor is bad. its on the fire wall. its a comman thing with them year chevys. i had 6 ...
...unit(dule cliamte) lights up and responds to the buttons but nothing comes out of the vents. ase mechanic: Sounds like a problem with the front blower motor. there is a blower motor resistor for the ...
Question about Ford F-250
...turn the air or the heat on i can hear the compressor kick on but it dosen't blow cold or hot? any help would be appreciated Roger it sounds like the blower motor is not comming on. There is ...
unit assembly to fix gauge...It wasn't cheap...Should have been a recall but it wasnt...However I don't have enough info for the heat/cool problem...Is the blower motor running all the time or does it
...turn fan knob from low to high with engine OFF...After goign from low to high and back a few times you can see if the blower motor is responding to signal from switch. Listen for a whine, squeal, ...
...unit. I replace the fuse and the blower will work. shortly after I turn it to AC the fuse will blow again The ac clutch is most likely bad,but if the blower motor is going out ,this could happen ...
Question about Ford F-250
unit. Turn on the blower through the climate control (heat, A/C, or whatever) and wiggle the connector to see if the blower turns on. If starts working, then an easy solution is pull the connector off
...unit not switching, but that is less likely. It does not sound like a resistor because most resistors break in the high position. The first thing I would do is check for good ground and positive feed ...
845 questions posted
Usually answered in minutes!
907 Questions
705 Questions
442 Questions
465 Questions
399 Questions